Intel BLKD945GCLF, 10-Pack BLKD945GCLF?KIT ユーザーズマニュアル

35 

Figure 14 shows the location of the Desktop Board’s BIOS configuration jumper block. 

 

 

 

Normal (default) (1-2) 

The BIOS uses the current configuration and 
passwords for booting. 

 

Configure (2-3) 

After the Power-On Self-Test (POST) runs, the 
BIOS displays the Maintenance Menu.  Use this 
menu to clear passwords. 

 

Recovery (None) 

The BIOS recovers data from a recovery diskette 
in the event of a failed BIOS update. 

This procedure assumes that the board is installed in the computer and the 
configuration jumper is set to normal mode. 
1.  Observe the precautions in "Before You Begin" on page 21. 
2.  Turn off all peripheral devices connected to the computer.  Turn off the computer.  

Disconnect the computer’s power cord from the AC power source (wall outlet or 
power adapter). 

3.  Remove the computer cover. 
4.  Find the configuration jumper block (see Figure 14, B). 
5.  Place the jumper on pins 2-3 as shown below. 

6.  Replace the cover, plug in the computer, turn on the computer, and allow it to 

boot. 

7.  The computer starts the Setup program.  Setup displays the Maintenance menu.   
8.  Use the arrow keys to select Clear Passwords.  Press <Enter> and Setup displays a 

pop-up screen requesting that you confirm clearing the password.  Select Yes and 
press <Enter>.  Setup displays the maintenance menu again. 

9.  Press <F10> to save the current values and exit Setup. 
10. Turn off the computer.  Disconnect the computer’s power cord from the AC power 

source. 

11. Remove the computer cover.