Whirlpool W10224610A ユーザーズマニュアル

9. Attach angled end of long hose to fill valve at bottom of dryer 

back panel. Screw on coupling by hand until it is seated on fill 
valve connector. 

10. Using pliers, tighten the coupling an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

11. Check that the water faucets are on.

12. Check for leaks around “Y” connector, faucet, and hoses.

Check the levelness of the dryer. Check levelness first side to side, 
then front to back.

If the dryer is not level, prop up the dryer using a wood block. Use a 
wrench to adjust the legs up or down and check again for levelness.

1. Check that all parts are now installed. If there is an extra part, go 

back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials. 

4. Check the dryer’s final location. Be sure the vent is not crushed or 

kinked.

5. Check that the dryer is level. See “Level Dryer.”

6. Remove the blue protective film on the console and any tape 

remaining on the dryer.

7. Wipe the dryer drum interior thoroughly with a damp cloth to 

remove any dust.

8. Read “Dryer Use.”

9. For power supply cord installation, plug into a grounded outlet. 

10. Check that gas supply is on.

11. Check for leaks.

12. Be sure the water faucets are on.

13. Check for leaks around “Y” connector, faucet, and hoses.

14. If you live in a hard water area, use of a water softener is 

recommended to control the buildup of scale through the water 
system in the dryer. Over time, the buildup of lime scale may clog 
different parts of the water system, which will reduce product 
performance. Excessive scale buildup may lead to the need for 
certain part replacement or repair.

15. Select a Timed Dry heated cycle, and start the dryer. Do not select 

the Air Only Temperature setting.

■

Controls are set in a running or “On” position.

■

Start button has been pushed firmly.

■

Dryer is plugged into an outlet and/or electrical supply 

 

is connected.

■

Household fuse is intact and tight, or circuit breaker has 

 

not tripped.

■

Dryer door is closed.

This dryer automatically runs an installation diagnostic routine at the 
start of its first cycle.

If you receive an L2 code, there may be a problem with your 
home power supply keeping the dryer’s heater from turning on. 
See “Troubleshooting.”

If you receive an AF code, your dryer vent may be crushed or 
blocked. See “Troubleshooting.”

NOTE: You may notice a odor when the dryer is first heated. This 
odor is common when the heating element is first used. The odor 
will go away.