Hitachi hdc-401ex ユーザーズマニュアル
■ Setting the Batteries
●
Turn off the camera power before replacing the batteries.
●
Do not open the battery/SD memory card cover using a violent motion.
The cover may be damaged.
The cover may be damaged.
●
When opening/closing the battery/SD memory card cover, be careful not to
drop the batteries.
●
It is recommended that the batteries be removed and stored separately if
the camera won
the camera won
,
t be used for a long period of time.
The HDC-401EX can be used with AA alkaline dry batteries and AA nickel metal
hydride batteries. (HR-3SB by Hitachi Maxell, Ltd. is recommended.)
See“Remaining Battery Power Display”for the remaining battery power
displayed on the LCD monitor.
hydride batteries. (HR-3SB by Hitachi Maxell, Ltd. is recommended.)
See“Remaining Battery Power Display”for the remaining battery power
displayed on the LCD monitor.
●
AA manganese dry batteries cannot be used.
●
The two AA alkaline dry batteries included in the package are provided to help you check the
basic operations of the digital camera. If you are shooting real targets, replace them with
commercial AA alkaline dry batteries or AA nickel metal hydride batteries.
basic operations of the digital camera. If you are shooting real targets, replace them with
commercial AA alkaline dry batteries or AA nickel metal hydride batteries.
（Kept with LCD monitor on and internal memory in use）
●
The figures in the table are reference values until the batteries go flat, assuming that images are captured in
a standard environment in the 2304 x 1728/normal mode under the following conditions and played
continuously at a speed of approximately 3 seconds per frame. They are not guaranteed. The actual figures
may be lower, depending on the condition or environment in which the camera is used.
a standard environment in the 2304 x 1728/normal mode under the following conditions and played
continuously at a speed of approximately 3 seconds per frame. They are not guaranteed. The actual figures
may be lower, depending on the condition or environment in which the camera is used.
［Continuous］Images are captured continuously without flash.
［Cyclic］Images are captured by repeating the sequence of
“Checking the subjects for 5 seconds”→“Capture”→“Playback for 5 seconds.”
［Cyclic］Images are captured by repeating the sequence of
“Checking the subjects for 5 seconds”→“Capture”→“Playback for 5 seconds.”
※In both modes, all images are erased once the memory gets full.
●
Even when the power is off, the HDC-401EX carries a very small amount of current to back up the internal clock. It is
recommended that the batteries be removed and stored separately if the camera won
recommended that the batteries be removed and stored separately if the camera won
,
t be used for a long period of time.
Reference Battery Life
Applicable Batteries
18
Open the battery/SD memory card cover by
sliding it in the direction of the arrow.
sliding it in the direction of the arrow.
17
1
Set the batteries by aligning the + and --
marks with the marks in the battery
compartment.
marks with the marks in the battery
compartment.
2
Close the battery/SD memory card cover.
3
Cyclic
Battery type
Continuous
Flash
No flash
Playback time
AA alkaline dry battery LR6
Approx. 900 images Approx. 200 images Approx. 500 images Approx. 190 minutes
Full battery power
Low battery power
Running out of battery
（In this condition the flash or Formatting
may not work properly. It is
recommended that you replace the batteries with new ones.）
No battery. Replace with new batteries.
Displayed when the AC adapter (sold separately) is in use.
●
The remaining battery power may not be displayed correctly, depending on
the use condition and environment in which the camera is used.
the use condition and environment in which the camera is used.
●
Use the display of remaining battery power only as a reference.
Remaining Battery Power Display
P74
Getting
R
eady
Basic
Operations