Lucent Technologies 555-670-111 ユーザーズマニュアル
MERLIN LEGEND Communications System Release 7.0
System Programming
System Programming
555-670-111
Issue 1
April 1999
Programming with SPM
2-74
Surrogate Mode Programming
2
Surrogate Mode Programming
2
Surrogate mode allows qualified service personnel to perform system
programming at an offsite service location. The actual communications system
hardware does not have to be installed — the programmer needs a power supply,
carrier, processor, and a direct connection from the PC to the processor module.
By following a customer’s set of completed planning forms, the system can be
programmed as if the appropriate modules, trunks, telephones, and other
communications equipment have been installed. When system programming is
completed, a system backup is performed to save the information on disk. This
backup disk is then taken to the new installation site and used with the Restore
option to provide complete system programming for a new communications
system.
programming at an offsite service location. The actual communications system
hardware does not have to be installed — the programmer needs a power supply,
carrier, processor, and a direct connection from the PC to the processor module.
By following a customer’s set of completed planning forms, the system can be
programmed as if the appropriate modules, trunks, telephones, and other
communications equipment have been installed. When system programming is
completed, a system backup is performed to save the information on disk. This
backup disk is then taken to the new installation site and used with the Restore
option to provide complete system programming for a new communications
system.
Table 2-16.
Optional Programming after Upgrade to Release 7.0
Feature
Sequence
Voice Announce
Receive
Receive
Extensions
→
Dial ext. no.
→
Enter
→
SysProg
→
Start
→
Choose a button
→
ListFeat
More
→
More
→
More
→
More
→
VoiceAnnounce
Caller Number and
Name on Caller ID
Name on Caller ID
LinesTrunks
→
More
→
LS-ID
Delay
→
EntryMode
→
Type trunk no.
→
Enter
Priority Call
Queuing
Queuing
Extensions
→
More
→
Grp
Calling
→
More
→
Priority
→
Enter extension number of group
→
Enter
→
Enter Group Priority (1–32)
→
(To program the
next group, select
Next
)
→
Enter
→
Exit
→
Support
→
Enter extension number of group
→
Enter
→
Enter Support Group
→
(To program the next
group, select
Next
)
→
Enter
→
Exit
→
Exit
→
Exit
Tip/Ring
Functionality on
412 LS-ID-ETR
and
016 ETR Modules
Functionality on
412 LS-ID-ETR
and
016 ETR Modules
Extensions
→
More
→
More
→
ETR
→
Type ext. no.
→
Enter
→
Type ETR tip/ring port
→
Select port
type
→
Enter
→
Exit
→
Exit
Rotary Signaling
on Tip/Ring Ports
on Tip/Ring Ports
Extensions
→
More
→
More
→
RotaryEnabl
→
Type
rotary ext. no.
→
Enter
→
Exit
→
Exit