Mitel 2700-1398-B1 ユーザーズマニュアル
Mitel NuPoint Messenger Technical Documentation - Release 7.0
Exit from the offline or online menus, or FCOS, LCOS, GCOS
menus, without saving any entries.
menus, without saving any entries.
Q + Y
Stop scrolling a displayed report.
Ctrl-S
Resume scrolling a displayed report.
Ctrl-Q
Return to the NuPoint Voice application when a # prompt is
displayed.
displayed.
Ctrl-D or
type exit
type exit
Return to the Reports Menu if you paused the display
Q + return or
Esc,Esc + return
Esc,Esc + return
Preparing for a Configuration Session
•
Before you begin a configuration session, you need the following:
• The
Reference and Configuration Manual
•
A NuPoint Messenger server console (video monitor and keyboard) and NuPoint Voice
module, with power on
module, with power on
•
At least two telephones for configuration testing
•
A blank 3.5-inch diskette on which you can copy your configuration
•
Completed worksheets (blank worksheets are included in Volume 2)
1
Using NuPoint Voice Software
The NuPoint Messenger server (the server) is a set of hardware and software used for adaptive
information processing. When you configure your software, you need to choose one or more
applications, then configure a number of modifiers common to all of the applications. Each
application is discussed in its own chapter. The modifiers are discussed in this chapter and
following chapters where applicable. When one of the modifiers operates differently in one
application compared to the others, this is highlighted in the application chapter.
information processing. When you configure your software, you need to choose one or more
applications, then configure a number of modifiers common to all of the applications. Each
application is discussed in its own chapter. The modifiers are discussed in this chapter and
following chapters where applicable. When one of the modifiers operates differently in one
application compared to the others, this is highlighted in the application chapter.
“Configuration” is the process of organizing application and modifier data on worksheets, then
entering the data at a server console. This data is stored in a configuration file on the hard disk,
and controls call processing.
entering the data at a server console. This data is stored in a configuration file on the hard disk,
and controls call processing.
Procedures
The following frequently-used procedures do not fit into any one category. You must use them
when performing many other procedures that are mentioned elsewhere in this manual. These
procedures are located in Volume 2 of this manual.
when performing many other procedures that are mentioned elsewhere in this manual. These
procedures are located in Volume 2 of this manual.
Procedure Number
Activate the Inactive Configuration
Activate the Inactive Configuration
CP 7002
Add or Delete Feature Bits
CP 5011
Assign an FCOS to a Mailbox
CP 5003
Customize an FCOS Copy
CP 5007
Define a Line Group
CP 5010
Duplicate a Configuration
CP 5044
Perform a Floppy Backup
CP 5703
Run a System Configuration Report
CP 4353
©Copyright 2002, Mitel Networks Corporation
7