Honeywell MicroDock II ユーザーズマニュアル
13
MicroDock II
Maintenance
4.
Allow the battery to obtain a full charge (2 to 4 hours,
depending upon how many docking modules are con-
nected to this station).
depending upon how many docking modules are con-
nected to this station).
If a docking module is in queue waiting to charge, the
CHARGE LED flashes red (all charging modules).
CHARGE LED flashes red (all charging modules).
When the docking module begins charging, the
CHARGE LED stops flashing and lights solid red.
CHARGE LED stops flashing and lights solid red.
The CHARGE LED lights green when the charging
process is complete. If there are other docking mod-
ules in queue, waiting to charge, they will begin
charging.
process is complete. If there are other docking mod-
ules in queue, waiting to charge, they will begin
charging.
The CHARGE LED deactivates when the detector is
removed.
removed.
Maintenance
a
Warning
No user-serviceable parts inside.
a
Caution
Confirm that the inlet filter is free of dirt and replace if
required. To order replacement parts, refer to
Replacement Parts and Accessories in the MicroDock II
Base Station User Manual.
required. To order replacement parts, refer to
Replacement Parts and Accessories in the MicroDock II
Base Station User Manual.
To maintain the station in good operating condition, perform the
following basic maintenance as required.
following basic maintenance as required.
• Clean the exterior with a soft, damp cloth. Do not use sol-
vents, soaps, or polishes.
• Do not immerse the station in liquids.