Regency E21-LP3 ユーザーズマニュアル

 Regency

®

 E21-3 Gas Fireplace Insert

6)  Connect the ON/OFF switch wires by taking 

the black and red wires with the female 
ends and connecting them to the ON/OFF 
switch.

8)  The power cord should be run behind the 

faceplate panel.

9)  Attach the brass trim to the faceplate by 

drilling a 1/8" hole through into the faceplate 
using the hole in the trim as a guide.  Fasten 
the trim to the faceplate panels using the 
gold plated screws.  See diagram 4.

7)  Tuck the wires into the faceplate to keep 

them away from the insert using the clip 
provided.  Attach the clip to the rear of the 
faceplate to ensure that the wires do not 
touch the side of the unit.  See diagram 3.

10) Attach the faceplate panels to the insert 

body using the 4 remaining black screws. 
See diagram 5.

11) Push the logo plate into the two holes in 

the bottom left corner of the faceplate. See 
diagram 4.

1)  Lay the faceplate panels fl at, face down on 

something soft so they don't scratch.

2)  Take the top faceplate and align the holes 

in it with the holes in the side panels. Using 
the screws provided, attach from the top of 
the panel (the holes in the top panel are 
slightly larger than the holes in the side 
panel to facilitate easier installation). See 
diagram 1.  

4)  Place the trim on the assembled faceplate 

panels, aligning the wire connections from 
the switches with the notch on the left side 
panel.

5)  Connect the fan switch wires by taking the 

black and red wires with the male ends (in 
the grey harness) and connect them with 
the wire connectors from the fan speed 
control.

3)  Using the connectors provided, join the left 

side trim (with the ON/OFF switch) to the 
top trim. See diagram 2.  Connect the right 
side trim to the top trim.