Regency Wraps P36-NG4 ユーザーズマニュアル

Regency

P36-4 Gas Log Fireplace

INSTALLATION

FLUEING

Regency

Direct Vent System (Flex)

Horizontal Terminations Only

These ﬂ ueing systems, in combination with the P36 Room Sealed Gas Fireplace, have been tested and listed as a Direct Vent type ﬂ ue system
by the Australian Gas Association. The location of the termination cap must conform to the requirements in the Flue Terminal Locations diagram in
section "Exterior Flue Termination Locations."

Regency

Direct Vent (Flex) System Termination Kit (Part # 946-515) includes all the parts needed to install the P36 with a maximum run

of 1200mm.

1) 175mm dia. ﬂ exible liner (1200mm length)
2) 100mm dia. ﬂ exible liner (1200mm length)
3) spring

spacers

(4)

4) thimble

(2)

5) AstroCap termination cap (1)
6) screws

(12)

7) tube of Mill Pac (1)
8) plated

screws

(8)

9) screws #8 x 1-1/2" Drill Point, Stainless
Steel

(4)

If longer runs are needed, the Regency

Direct

Vent system (Flex) # 946-516 includes all the
parts needed to install the P36 with a maximum
3.0m run.

1) 175mm dia. ﬂ exible liner (3.0m length)
2) 100mm dia. ﬂ exible liner (3.0m length)
3) spring

spacers

(7)

4) thimble

(2)

5) AstroCap termination cap (1)
6) screws

(12)

7) tube of Mill Pac (1)
8) plated

screws

(8)

9) screws #8 x 1-1/2" Drill Point, Stainless
Steel

(4)

Notes:
1) Liner sections should be continuous without any joints or seams.

2) Only Flex pipe purchased from Regency

may be used for Flex installations.

3) If you are installing the P36 into a Regency

Mantel Kit, use the minimum horizontal vent height (centre-line of 1029mm). Remember

to include the mantel base in your calculations and to maintain the 32mm clearance (38mm with Flex) to the underside of the mantel
top.

6-7/8"

(173mm)

dia. Flue pipe

4" (102mm)

dia. flue pipe

spring spacer

Termination Cap

(Part# 946-578/P)

AstroCap

(patented)

Wall Thimble