Regency Wraps P36-NG4 ユーザーズマニュアル

Regency

®

 P36-4 Gas Log Fireplace

1)  Read and understand these instructions 

before operating this appliance.

2)  Check to see that all wiring is correct and 

enclosed to prevent possible shock.

3)  Check to ensure there are no gas leaks.

4)  Make sure the glass in the door frame is 

properly positioned. Never operate the 
appliance with the glass removed.

5)  Verify that the flueing and cap are 

unobstructed.

6)  Ensure that the brick panels are installed.

7)  Verify log placement. If the pilot cannot be 

seen when lighting the unit, the logs have 
been incorrectly positioned.

8)  The unit should never be turned off, and on 

again without a minimum of a 60 second 
wait.

240 Volt AC power is needed for the fan switch 
and blower. The fan can be hard wired if desired. 
A terminal block is provided on the left hand side 
of the unit. A three wire power cord can also be 
used and plugged into a suitable receptacle.

1)  Shut the power off.

2)  Open the bottom louvre door. 

3)  Remove the terminal block cover.

4)  Slide the fan in towards the rear of the unit 

and slip it over the two mounting studs. 
Ensure that the fan blades do not rub 
against the valve tubing.

 

Optional: If you require extra space to slide 
the fan to the back, the left spring can be 
unhooked from the bracket. 

5)  Wire the fan to the terminal block as shown 

in the wiring diagram below.

6)  Connect white wire from fan to neutral of 

terminal block.

7)  Slide the  thermodisc into the bracket clip 

on the underside of the fi rebox.

8)  Connect black wire from fan to the 

thermodisc.

9)  Connect fan ground cable to ground lug. 

Refer to wiring diagram.

10) Attach the ground wire to the stove (ground 

lug provided).

11)  Attach black wire from thermodisc to terminal 

block. 

12) Hard wire into terminal block and to fan 

speed controller. Wires not supplied.

13) Attach the terminal block cover. If the left 

spring was unhooked in step 4), hook it back 
into the bracket.

1)  Shut the power off.

2)  Reverse the above instructions.