Hearth & Home Technologies HUDBAY-FS ユーザーズマニュアル
Page 32
10/08
Quadra-Fire • Hudson Bay • 7003-121 Rev. i
H. Blower Installation
KIT CONTENTS: Blower; 2 female spade wire connectors.
TOOLS REQUIRED: Powered screwdriver with a #2 Phil-
lips head bit.
lips head bit.
Figure 8.20
Disconnect power to the appliance. To access
the blower, open the door located on the front of the pedes-
tal. Remove the two screws holding the blower bracket in
place.
tal. Remove the two screws holding the blower bracket in
place.
Figure 8.21
Disconnect wires to the blower motor. Remove
the blower from the bracket.
The blower motor comes standard with two male spade
wire connectors. If your appliance has a different con-
nection, use the two female spade wire connectors pro-
vided to modify the appliance wiring harness.
wire connectors. If your appliance has a different con-
nection, use the two female spade wire connectors pro-
vided to modify the appliance wiring harness.
Figure 8.22
Install the new blower by slipping grommets
over studs on the blower bracket. Reinstall the blower and
bracket. Connect the wires. Install screws. Restore power
to the appliance.
bracket. Connect the wires. Install screws. Restore power
to the appliance.
Figure 8.23 Blower Wiring Diagram
F
M
F
F
Thermal Disk
Fan Assembly
BLK
BLK
GRN
WHT
BLK
F
M F
M
WHT
Fan Speed Control
BLK
BLK
Strain Relief Bushing
Power Cord (110 VAC)
Ground
WHT
BLK
F = Female spade connector
M = Male spade connector
M = Male spade connector