Hearth & Home Technologies 5100I-GD-B ユーザーズマニュアル

Page 

September 1, 2008

R 

438-0380D

1.  Remove the panel and trim set. See

for complete details.

2.  Remove 2 screws on blower housing.
.  Unhook the wires from the blower.
4.  Slide blower housing out.
5.  Remove  2  screws  from  blower  and  remove  from

housing.

6.  Attach new blower to housing.
7.  Re-assemble in reverse order.

•  Frequency: As needed
•  By: Homeowner / Qualified service technician
•  Task: See the following instructions.

Remove 

2 Screws

•  Frequency: As needed
•  By: Homeowner / Qualified service technician
•  Task: See the following instructions.

1.   Remove all ash from firebox, and extinguish all hot 

embers before disposal into a metal container.

.  Remove ceramic blanket from above the baffle.
3.  With a 3/16 inch Allen wrench, remove 2 front manifold

tube retainer bolts on the air channel under the end of

the front tubes.  NOTE:  Soak the bolts with penetrating 

oil for at least 15 minutes before trying to remove them.

4.  To remove manifold tubes, slide the tube to one side

until one end is out of its hole. Then, while lifting that

end of the fiber board baffle, pull tube up over the air 

channel and out of hole at the other end. It is necessary

to remove the first two tubes in order to remove the 

baffle.  

NOTE: When replacing the manifold tubes,

be sure the tube with the larger holes is placed in the

front for your insert to operate properly.

5.  Slide fiber board baffle forward to front of stove and 

straight out through door.

6.  To install the fiber board baffle, repeat steps  through 

 in reverse.  Be sure the fiber board baffle and ceramic 

blanket are pushed back fully into position.