Hearth & Home Technologies 4100I-NL-B ユーザーズマニュアル

Page 14

   September 1, 2008

R

250-7201E

1.  Remove contents from box being careful not to scratch or damage cast trim pieces.

2.  Lay the panel set face down on protective covering to prevent scratching the painted surface.

.  Secure panel set together with screws provided.  

4.  Now bend the tabs down toward the backside of the panel set, on top piece and on each leg.  Leave panel set face down.

5.  Place the corresponding cast trim pieces (2 cast trim legs and 1 cast trim header) underneath panel set, also face down.

6.  Place washer provided over tab and secure the trim and panel together with screw.  Continue for all tabs.

7.  Secure cast footers with screws. 

8.  Slide assembled panel and trim over top of the insert into place. 

9.  Secure panels to insert with 8-2 sheet metal screws through tabs on bottom lower inside corners on side panels.

Included in Panel Kit:  (2) side panels, left and right; (1) panel top; (2) trim pieces; (1) trim top; (1) fastener package.

Included in Cast Trim Kit:  (2) cast trim legs, left and right; (1) cast trim header; (2) cast trim footers, left and right.
Tools Needed: Powered Phillips Head Screw Driver

1. Screw side panels 

to top panel

2. Bend tabs 

. Install Cast Trim

 Header

2. Bend tabs 

Tab with screw hole to 

secure panel to insert

Secure side panels to insert with screws

STANDARD SIZE:  30-1/2” h x 44-3/4”w

BASIC STANDARD SIZE:  30”h x 40”w

1. Repeat Steps 1 -  above.

2. To assemble the trim, attach the 2 side trim pieces to the top trim at each corner using the “L” bracket 

included in fasteners package. 

.  Slide panel and trim over top of the insert and into position. 

Tab with screw 

hole to secure 

panel to insert

Screw side 

panels to top 

panel

View of "L" Bracket 

installed