Fujitsu ASU18T ユーザーズマニュアル

En-6

Fig. 1 Indoor Unit

1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button

3 Remote Control Signal Receiver

4 Indicator Lights (Fig. 3)
5 OPERATION Indicator Light (red)
6 TIMER Indicator Light (green)
7 SWING Indicator Light (orange)

(VERTICAL SWING)

8 SWING Indicator Light (orange)

(HORIZONTAL SWING)
●

If the TIMER indicator light flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting

(See page 15 Auto Restart).

9 Intake Grille (Fig. 4)
0 Air Filter
A UP/DOWN Air Direction Flaps
B RIGHT/LEFT Air Direction Louvers

(behind UP/DOWN Air Direction Flaps)

C Drain Hose
D Air Cleaning Filter (optional)

Fig. 5 Outdoor Unit

E Intake Side
F Outlet Side

Fig. 6 Remote Control Unit

G SLEEP Button
H MASTER CONTROL Button
I SET TEMP./SET TIME Buttons (

)

J Signal Transmitter
K TIMER Button
L FAN CONTROL Button
M START/STOP Button
N Battery compartment lid

Inside of the battery compartment lid (Fig. 7)
O AIR FLOW DIRECTION Button
P ENERGY SAVE Button
Q CODE CHANGE (Slide Switch)

Switching the remote control unit code.
(Max. 4 units)

R TIME ADJUST Button
S TEST RUN Button

● This button is used when installing the air

conditioner and should not be used under
normal conditions as it will cause the air
conditioner’s thermostat function to oper-
ate incorrectly.

● If this button is pressed during normal op-

eration, the unit will switch to test opera-
tion mode, and the indoor unit’s OPERA-
TION indicator light and TIMER indicator
light will begin to flash simultaneously.

● To stop the test operation mode, either

press the TEST RUN button once again, or
press the START/STOP button to stop the
air conditioner.

T ACL Button

U Remote Control Unit Display (Fig. 8)
V Transmit Indicator
W Clock Display
X Operating Mode Display
Y Timer Mode Display
Z Fan Speed Display
[ Temperature Set Display
\ Timer Set Indicator
] Temperature Set Indicator