Whirlpool 819041994 ユーザーズマニュアル

ページ / 32
7
3. If needed, drill 
¹⁄₈" holes into the wall sleeve. Then fasten the 
grille to the wall sleeve with the screws with washers.
4. If existing wall sleeve has insulation that does not need to be 
replaced, skip to Step 7. Otherwise, replace the insulation.
5. Remove the backing from the horizontal insulation strip and 
attach it to the inside of the wall sleeve.
6. Remove the backing from the vertical insulation strip and 
attach it to the inside front of the wall sleeve as shown below.
7. If the depth of your existing sleeve is less than or equal to 18" 
(45.7 cm), go to Step 10. Otherwise, cut the baffle and 
support blocks according to the lengths in the following table.
8. Slide the baffles into the slots of the support blocks. 
9. Slide the baffle and support block assemblies inside the wall 
sleeve as shown.
10. Install the air conditioner into the wall sleeve.
11. The universal trim frame must be used with this wall sleeve 
assembly. To assemble the universal trim frame, see 
“Complete Installation.” 
Install Air Conditioner in New Wall Sleeve
NOTE: Wall sleeve must be purchased separately.
Install the new grille that came with your air conditioner or 
new wall sleeve.
NOTE: If this grille is not installed in the wall sleeve, your air 
conditioner  will not operate correctly and the warranty will be 
void.
Handle air conditioner gently. 
Be sure your air conditioner does not fall out of the opening 
during installation or removal.
The place where the power cord exits the air conditioner 
should be no more than 4 ft (122 cm) from a grounded outlet.
Be sure the wall where the air conditioner will be installed will 
support the weight of the air conditioner.
Do not install the air conditioner where the plastic cabinet 
front will be exposed to a heat source that raises the surface 
temperature above 120ºF (49ºC).
Do not block the louvers in the front panel.
A. Vertical insulation strip
B. Horizontal insulation strip
A. Length (see chart below)
B. Support block
C. Baffle
Depth (D) of existing wall sleeve
Length (A)
18" (45.7 cm) < D < 18
⁵⁄₈" (47.3 cm)
³⁄₄" (1.9 cm)
18
⁵⁄₈" (47.3 cm) < D < 19³⁄₄" (50.2 cm)
1
³⁄₄" (4.5 cm)
19
³⁄₄" (50.2 cm) < D < 22 (55.9 cm)
4 (10.2 cm)
AC Plastic Grille Install 2.eps
OR
A
B
A
B
C
A
A. Wall 
B. Front of wall sleeve 
C. Baffle 
D. Support block
A
B
C
D
7
³
/
₃₂
"
(18 cm)
Excessive Weight Hazard
Use two or more people to move and install 
air conditioner.
WARNING
Failure to do so can result in back or other injury.