APC ACPSC2000 ユーザーズマニュアル

Electrical Hazard: Before performing maintenance on the cooling unit:
1. Turn the cooling unit off.
2. Unplug the cooling unit.

Warning: Damage to equipment may occur if:
1. Caustic substances are used to clean the cooling unit. 
2. The unit is subjected to excess water.
2. Air filters are cleaned too aggressively causing damage.

Wipe dirt and dust from the exterior surfaces with a soft, dry cloth. Dampen a cloth with a solution of 
warm water and mild detergent for heavily soiled areas.

Ensure all detergent is wiped from the surface with a clean, damp cloth to remove residue.

Check the air filter frequently after initially putting the cooling unit into service. Determine how long 
between cleanings you can wait. Keeping your air filter clean will maximize the performance and life of 
the cooling unit.

1. Remove the air filter. Press down on the two 

tabs on the top of the grill to release the filter 
and grill from the cooling unit. 

– Pull the air filter from under the small tabs 

at the edges on the inside of the grill. 

2. Clean the air filter. About every two to three 

weeks clean by gently vacuuming, wiping or 
knocking the edges of the filter on a firm 
surface to remove the excess dust. 

3. Wash the air filter. To remove excessive 

soil, soak the air filter in a solution of mild 
detergent and warm water. Allow to air dry. 

1. See “Remove the air filter” (above) for 

instructions to properly remove the air filter. 

2. Install a new, clean filter to the grill. Make 

sure the filter is secured under the tabs along 
the edges of the grill.

3. Attach the grill to the rear of the cooling unit. 

Set the bottom of the grill into the opening. 
Tabs on the grill bottom should enter the slots 
in the bottom of the opening. Tip the top of 
the grill up and into the opening. The tabs on 
the top of the grill should snap into place.

na3358a