Janome MC 200E ユーザーズマニュアル
8
Inserting the bobbin
z
Place the bobbin in the bobbin holder with the
thread running off in a counterclockwise direction.
thread running off in a counterclockwise direction.
q
Thread
w
Bobbin holder
* Refer to the threading chart shown on
the hook cover plate.
the hook cover plate.
q
w
r
r
t
4
3
2
1
e
x
Guide the thread into the notch on the front of
the bobbin holder.
Draw the thread to the left, sliding it between the
tension spring blades.
the bobbin holder.
Draw the thread to the left, sliding it between the
tension spring blades.
e
Front notch
c
Continue to draw the thread lightly until the
thread slips into the side notch.
Pull out about 10 cm (4˝) of thread to the rear.
thread slips into the side notch.
Pull out about 10 cm (4˝) of thread to the rear.
r
Side notch
v
Reattach the hook cover plate.
t
Hook cover plate