Multiquip LS600P ユーザーズマニュアル

1.  Read safety instructions at the 

beginning of manual.

2.  Clean the entire pump, removing dirt 

and dust, particularly the  engine 

cooling air inlet, and heat exchanger.

3.  Check  the air filter  for  dirt and dust.  If air filter is dirty, 

replace air filter with a new one as required.

4.  Check fastening nuts and bolts for tightness.

NeveR operate the pump in a confined 

area or enclosed area structure that 

does not provide ample free flow of air.

ALWAYS wear approved eye and 

hearing protection before operating 

the pump.

NeveR operate the pumps's engine 

with the  engine hood removed. The 

possibility exists of hands, long hair, 

and clothing becoming entangled with 

the V-belt, causing injury and bodily 

harm.
NeveR place hands or feet inside 

the hopper. 

ALWAYS make while the 

engine is running. 

ALWAYS shut down 

the engine before performing any kind 

of maintenance service on the pump.

Reference Figures 5, 6, and 7 for the location of any control 

or component referenced in this section.

Handle fuel safely. Motor fuels are highly flammable 

and can be dangerous if mishandled. 

DO NOT smoke 

while refueling. 

DO NOT attempt to refuel the pump if 

the engine is hot or running.

1.  Check the fuel gauge (Figure 9) built into the fuel tank 

cap to determine if the pump's engine fuel is low. 

2.  If fuel is low,  remove fuel filler cap and fill with #2 diesel 

fuel (Figure 10).

Diesel fuel is extremely flammable, and 

its vapors can cause an explosion if 

ignited.  

DO NOT start the engine near 

spilled fuel or combustible fluids. 

NOT fill the fuel tank while the engine 

is running or hot. 

DO NOT overfill tank, since spilled fuel could ignite if it 

comes into contact with hot engine parts or sparks from 

the ignition system. Store fuel in approved containers, in 

well-ventilated areas and away from sparks and flames. 

NeveR use fuel as a cleaning agent.

G

I