NAD C545BEE ユーザーズマニュアル

A wireless remote control is provided with your compact disc player, 
enabling you to operate playback functions from the comfort of your chair 
or from virtually anywhere in the room. For reliable operation there should 
be a clear line-of-sight path from the remote control to the front of the CD 
player. If the player does not respond to remote commands, it may be that 
this line-of-sight path is obstructed by clothing, paper or furnishings.

Most of the buttons on the remote control handset have the same effect as 
the corresponding buttons on the front panel of the player. In addition, the 
handset is equipped with some extra buttons like the following function 
keys.

Using the direct-entry numeric keypad (0 to 9) causes the C 545BEE to jump 
directly to the beginning of a numbered track and commence play. Thus, to 
play Track 5, simply press “5”. To play Track 20, press “2” and “0”.

To repeat a sequence, implement the following procedures:
1  Press [RPT A-B] at your chosen starting point.  
2  Press [RPT A-B] again at your chosen end point. The repeat sequence 

begins. 

3  Press [RPT A-B] again to cancel the sequence. 

Toggle to reduce, turn off and restore VFD brightness. 

Use [PROG] button to start, review, edit or exit programming mode.  In 
combination with [PROG] button, the [CLEAR] button allows the deletion of 
a programmed track during program review or edit sequence.  

 

The [FILTER] button is used for selecting the bandwidth of the audio low 
pass filter for the CD, MP3 and WMA media being played.  The options are 
NORMAL Bandwidth and SLOW Bandwidth.  For some recordings the SLOW 
Bandwidth may provide a wide frequency range and spatial feeling. Toggle 
CD 8's [FILTER] button to select “NORMAL” or “SLOW” mode.  “NORMAL FILTER” 
or “SLOW FILTER” will be correspondingly shown in the VFD. 

  normal: Select NORMAL bandwidth to engage a standard CD high-

pass filter slope for playback of CD, MP3, and WMA music through the 
two channel stereo audio jacks. 

  Slow: Select SLOW bandwidth to engage a gentle high-pass filter 

slope for playback of CD music through the two channel stereo audio 
jacks.  This feature is particularly useful for higher bit rate recordings.

The power cord is disconnected.

•

Plug the power cord into the wall outlet 
securely.

•

No disc is inserted.

•

Insert a disc. 

•

The disc is loaded upside down.

•

Reload the disc with the label side UP.

•

The disc is too dirty.

•

Clean the disc.

•

The equipment connected with the audio 
cable is not set to receive CD signal output.

•

Select the correct input mode of the audio 
receiver so you can listen to the sound from 
the C 545BEE.

•

The power of the equipment connected with 
the audio cable is turned off.

•

Turn on the equipment connected with the 
audio cable.

•

The C 545BEE is subject to vibration or physical 
shock from external sources.

•

Change the installation location.

•

The remote control is not pointed at the 
remote sensor on the CD player.

•

Point the remote control at the remote 
sensor of the CD player.

•

The remote control is too far from the CD 
player.

•

Operate the remote control closer to the 
CD player.

•

The remote control batteries are dead.

•

Replace the remote control batteries.

•