Havis-Shields C-AS-1025 プリント

 

 
TOOLS REQUIRED: 

Standard and Metric socket set with 6”extension. 
Standard and Metric wrench set 
#20 and #15 Torx driver 

8  

¼-20 X ¾”Hex Head Bolt 

GSM33001 

 

8 

¼” Flat Washer 

GSM31005 

 

6 

¼” Lock Washer   

GSM31026 

 

8 

¼-20 Hex Nut 

GSM30005 

1.  Remove inner front seat mounting bolts near transmission 

hump. Just loosen outboard bolts. 

2.  Place ¼ - 20 x ¾” Hex head bolts  into under side tracks of 

trak mount.  

3.  Position trak mount in desired location before tightening 

down hump mount. 

4.  Mount rear hump brackets to under side of trak. 
5.  Place trak with positioned hump mount brackets over 

transmission hump and onto front and rear seat mount 
studs. Place seat bracket on top of hump mount brackets 
and replace seat mount bolts. 

6.  Slide console up to dash and secure to trak mount with 1/4” 

hardware. 

7.  Unit is ready to accept equipment control heads.