Philips FW585C ユーザーズマニュアル

27

• If a fault occurs, check the points listed

below before taking the system for
repair.

• Should any problems persist after you

have made these checks, consult your
nearest dealer or service center.

NO DISC” is displayed.

• The disc is inserted upside down.
™ Place CD with printed side up.
• Moisture condensation at the lens.
™ Wait until lens has adjusted to normal

room temperature.

• There is no disc in the CD tray.
™ Insert a CD.
• The CD is dirty, badly scratched or

warped.

™ Clean or replace the CD.
• The CD lens is dirty or dusty.
™ See section under Maintenance.

DISC NOT FINALIZED” is

displayed.
• The CD-RW or CD-R disc is not properly

recorded for the use of a standard CD
player.

™ Read the instruction booklet of your CD-

Rewritable or CD-Recorder on how to
finalize a recording.

• The CD is badly scratched or dirty.
™ Replace or clean CD.

Poor radio reception.
• The signal is too weak.
™ Adjust the antenna.
™ Connect an external antenna for better

reception.

• The TV or VCR is too close to the stereo

system.

™ Separate the stereo system from the TV

or VCR.

Recording or playback cannot occur or
there is a decrease in audio level.
• Dirty tape heads, capstans or pressure

rollers.

™ See section on tape deck maintenance.
• Magnetic build-up in the record/

playback head.

™ Use demagnetizing tape.

System does not react when any button
is pressed.
• Electrostatic discharge.
™ Press STANDBY-ON to switch the

system off. Remove the AC power plug
from the wall outlet, then reconnect the
power plug and switch on the system
again.

• Batteries are exhausted.
™ Replace the batteries.

Timer not working.
• Clock is not set.
™ Set the clock.
• Timer is not switched on.
™ Press CLOCK/TIMER to switch on the

timer.

• Dubbing/recording is in progress.
™ Stop dubbing/recording.

Clock setting is erased.
• There was a power failure.
™ Reset the clock.

System displays features
automatically; buttons flash
continuously.
• Demonstration mode is switched on.
™ Press and hold Ç (on the system only)

for five seconds to switch off the
demonstration.

A howling sound at external source.
• You hear feedback when you are

listening and recording from the same
source simultaneously.

™ Press AUX to select CDR mode.

All lighted buttons are not lit.
• Equalizer Display is switched on in NITE

mode.

™ Rotate JOG to other Equalizer Display.

No or poor sound.
• Volume is not turned up.
™ Adjust VOLUME.
• The headphones are connected.
™ Disconnect the headphones.
• Speakers are not connected or are

connected wrongly.

™ Check that the speakers are connected

correctly.

™ Make sure the stripped speaker wire is

clamped.

Reversed left and right sound.
• Speakers are connected wrongly.
™ Check the speaker connections and

location.

Lack of bass sound or apparently
imprecise physical location of musical
instruments.
• Speakers are connected wrongly.
™ Check the speaker connection for

proper phasing, red/black wires to red/
black terminals.

Remote control has no effect on the
system.
• Wrong source is selected.
™ Select the source (CD, TUNER, etc.)

before pressing the function button,
(PLAY, PREV/NEXT, etc.).

• The distance to the system is too large.
™ Reduce the distance.
• Batteries are inserted incorrectly.
™ Insert the batteries with their polarities

(+/– signs) as indicated.