Multiquip HTN-27K-TCSL ユーザーズマニュアル

The purpose of this section is to assist the user in setting up  a
NEW  trowel. If your trowel is already assembled, (seat, handles,
knobs and battery), this section can be skipped.

Before packaging and shipping, this HTN SERIES Ride-On
Power Trowel was run and tested at the factory. If there are
problems, please let us know.

5.

Pay close attention to any wires that may be inside the
control handles. DO NOT pinch or cut any wires during
installation.

6.

Inside the plastic bag of parts are two knobs for the pitch
control tower cranks. Install these two knobs onto the tower
crank levers.

1.

Remove the seat from the protective wrapping.

2.

Remove the bolts on the bottom of the seat, and place seat
on the seat mounting plate, then insert the bolts through
the holes or slots on the seat mounting plate and tighten.

This trowel was shipped with a wet charged battery. This battery
may need to be charged for a brief period of time as per the
manufacturer instructions.

The seat is not installed on the trowel for shipping purposes.
To attach the seat perform the following:

Some models are equipped with
adjustable height handles. Adjust the
height by placing the bolt through the
set of holes that corresponds to the

most comfortable height.

To install the battery on the trowel, make sure that the battery is
well seated in the battery box.. Connect the positive cable to the
positive terminal on the battery first, then connect the negative
cable to the negative terminal. Close the plastic battery box cover
and secure the battery box.

There are two types of seats,
depending on what type of trowel
you have. J and B series trowels have

slots on the seat mounting plate that
allow fore and aft adjustment of the

seat. H-series trowels have a seat that is mounted on tracks,
similar to an automobile seat. This seat can be adjusted fore
and aft via the control lever under the front of the seat.

The new trowel cannot be put into
service until the pre-setup installation
instructions are completed. These
pre-setup instructions only need to

be performed at the time of
unpacking a 

NEW  trowel.

Use all safety precautions specified by the battery
manufacturer when working with the battery.  See further
specific safety information on page 12 of this manual.

 NOTE

 NOTE

 NOTE

1.

Remove the bolts from the plastic bag tied to the control
towers.

2.

Remove all protective wrapping and straps from the control
handles.

3.

Slip the top (loose) piece into the base of the corresponding
handle, making sure to line up the holes.

4.

Install the bolt through the lined up holes and tighten the
acorn nut onto the threaded end.

The steering control handles are not attached to the trowel's two
lower handles at the time of shipment. To attach the steering
control handles to the two lower handle assemblies perform the
following: