Jensen XA4200 ユーザーズマニュアル

XA4200, XA4300

Adjust the crossover to accommodate your
chosen installation method.

• LPF–(low pass filter) Select

this filter when the amplifier will
be driving woofers or
subwoofers.

• FULL–Crossover is not active,

amplifier is in “full range”
mode.

• HPF–(high pass filter) Select

this filter when the amplifier will
be driving full range/separate
speakers, and you want to limit
the “bass” going to these
speakers.

Crossover (X-OVER)

Indicators and Controls

A dual status LED indicator illuminates
red or green to indicate the status of
the amplifier.

Power / Protect Light

Green – Power applied, ON

Red

– Protection circuit activated, STANDBY

Tri-mode/Three channel operation

An amplifier is usually configured for tri-mode
operation when you want to use one amplifier to
drive a pair of front speakers and subwoofer(s).
In other words, when you want drive a complete
system with one amp. Your Jensen amplifier is
capable of tri-mode operation.

Important
Tri-mode operation requires using “passive
crossovers”. These crossovers are available at
your local retailer or install shop. Failure to
install these filters may damage your amplifier
and/or your speakers.

40Hz

0dB

12dB

40Hz

400Hz

MIN

MAX

X-OVER

REAR

HPF

FULL

LPF

X-OVER

BASS

FULL

LPF

HPF

FRONT

BASS

LEVEL

2CH

4CH

3CH

POWER/

PROTECT

L-CH X

R-CH X

L-CH X

R-CH X

X-OVER

LPF

HPF

FULL

X-OVER

LPF

HPF

FULL

FRONT

REAR

POWER/

PROTECT

5910 XA4CH_E.p65

01/23/01, 12:24 PM