Mitsubishi Electronics LDT52IV (MT819) ユーザーズマニュアル

21

E

Your monitor can be connected to a LAN allowing you to 
control it from a PC on the LAN. 
You can also confi gure the monitor to send e-mail notifi cation 
when it has a problem. 
The connection requires a commercially available LAN cable 
(UTP cable, Category 5, straight through).

Hub 

LAN terminal 

LAN cable (commercially available, straight) 

Network (LAN) 

TIPS

•  You must assign an IP address to the monitor by following 

the procedures in “Settings to connect to a LAN”. (See the 
description on the right.)

•  Your PC must be installed with Internet Explorer (version 6.0 

or later). 

•   To control the monitor via LAN, set RS-232C/LAN SELECT 

to LAN. (See page 7.)

•  You cannot use RS-232C and LAN control simultaneously. 

Set the monitor’s IP address and subnet mask to match the 
settings of your LAN. 
These settings can be made on either the monitor or a PC 
connected to the monitor.
The settings depend on the confi guration of your LAN. Ask 
your LAN administrator for details. 

„ To set on the monitor

Set RS-232C/LAN SELECT on the SETUP menu to LAN, and 
then set the LAN SETUP options. (See page 7.)
After setting each item, select SET and press 

MENU

.

DHCP CLIENT
If your LAN has a DHCP server and you wish to obtain an 
address automatically, change this setting to ON. 
To set the address manually, set this to OFF. 
IP ADDRESS
If the DHCP CLIENT is set to OFF, specify an IP address. 
Press 

 or 

  to select items, and press 

 or 

 to 

change the values.
SUBNET MASK
If the DHCP CLIENT is set to OFF, specify the subnet mask. 
Press 

 or 

  to select items, and press 

 or 

 to 

change the values.
DEFAULT GATEWAY
If the DHCP CLIENT is set to OFF, specify the default 
gateway. 
If you are not using a gateway, specify “0.0.0.0”. 
Press 

 or 

  to select items, and press 

 or 

 to 

change the values.
RESET
Resets the values of the LAN settings to the factory preset 
values. 
Select ON and then press 

MENU

.