Husqvarna 1153137-49 ユーザーズマニュアル

English – 41

1153137-49 Rev.1 2009-12-29

Following is a list of recommended cutting equipment for the Husqvarna chain saw model 455 Rancher, 455e Rancher 
and 460 Rancher. The combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-03 
Chainsaws and Z62.3-04 Chainsaw Kickback standards.

The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the 
corresponding maximum nose radius of a solid bar.

As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. 
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of 
sprocket teeth may be considered to have equivalent kickback energy.

A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent 
or less kickback energy than the sprocket-nose bar.

We recommend that you as replacement use the listed bars and chains or ”Type C Low-Kickback Saw Chains” which 
are available at your dealer.

Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the 
corresponding bar, see the table below

15

3/8

0,050

11T

Husqvarna H80, 
Husqvarna H46, 
Husqvarna H47

56

16

3/8

11T

60

18

3/8

11T

68

20

3/8

11T

72

24

3/8

11T

84

0,050

H80

H46

H47

0,058

H81

H42

H48