MTD 500 thru 510 ユーザーズマニュアル

8

NOTE: Certain engines may also be equipped with an
on/off switch.

•

Disconnect spark plug wire and ground against the 
engine to prevent unintended starting.

Service the engine with gasoline and oil as instructed in 
the separate engine manual packed with your log 
splitter. Read instructions carefully.

NOTE: Gasoline can be added to the engine when the
log splitter is in either the horizontal or vertical position;
however, there are less obstructions when the unit is in
the vertical position.

•

Attach spark plug wire to spark plug. Make certain 
the metal cap on the end of the spark plug wire is 

fastened securely over the metal tip on the spark 
plug.

•

Engines with choke lever:
Move choke lever on engine to CHOKE position.
(A warm engine may not require choking).

NOTE: Certain engines may be equipped with an on/off
switch. Check your separate engine manual to verify
engine controls.

•

Engines with primer:
Prime engine as instructed in separate engine 
manual.

•

The throttle control lever is located on the engine. 
Move engine throttle control lever to FAST or 
START position.

•

Grasp starter handle and pull rope out slowly until 
engine reaches start of compression cycle (rope 
will pull slightly harder at this point).

•

Pull rope with a rapid, continuous, full arm stroke. 
Keep a firm grip on starter handle. Let rope rewind 
slowly.

•

Repeat the previous steps until engine fires. When 
engine starts, move choke control (if equipped) 
gradually to RUN position.

•

If weather is cold, run wedge up or down beam 6 to 
8 times to circulate the hydraulic fluid.