Weed Eater 96024000100 オーナーマニュアル

23

Fender 

Battery

Battery 

Bracket

1.  Lift seat for bolt access.

2.  Disconnect BLACK battery cable then 

RED battery cable.

3.  Remove battery bracket bolt.

4.  Install new battery with terminals facing 

to the right, and away from seat as 

shown.

5.  Reinstall battery bracket and bolt.

6.  First connect RED battery cable to posi-

tive (+) battery terminal.

7. Connect BLACK grounding cable to 

negative (-) battery terminal. 

INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your 

riding mower to run poorly, stop running, or 

prevent it from starting.

•  Check  wiring.  Make  sure  all  wiring  and

connectors are secure.

Replace with 4 amp. or 5 amp. automotive 

type plug-in fuse.  The fuse holder is located 

under the fender.

Your engine speed has been factory set. Do 

not attempt to increase engine speed or it 

may result in personal injury. If you believe 

that the engine is running too fast or too slow, 

take your riding mower to a qualified service 

center for repair and/or adjustment. 
Your carburetor is not adjustable. If your 

engine does not operate properly due to 

suspected carburetor problems, take your 

riding mower to a qualified service center 

for repair and/or adjustment. 

IMPORTANT: Never tamper with the engine 

governor, which is factory set for proper en-

gine speed. Overspeeding the engine above 

the factory high speed setting can be danger-

ous. If you think the engine-governed high 

speed needs adjusting, contact a qualified 

service center, which has proper equipment 

and experience to make any necessary 

adjustments.