Multiquip BS46H90 ユーザーズマニュアル

The engine (Figure 3) must be checked for proper 

lubrication and filled with fuel prior to operation. Refer to the 

manufacturer's engine manual for instructions and details 

of operation and servicing.
1. 

fuel filler cap – Remove this cap to add unleaded 

gasoline to the fuel tank. Make sure cap is tightened 

securely. 

dO NOT over fill.

2. 

Throttle Lever – Used to adjust engine RPM speed. 

This lever is connect to the throttle lever cable located 

on the handle bars. Reference throttle cable installation 

procedure in this manual.

3. 

Recoil Starter (pull rope) – Manual-starting method. 

Pull the starter grip until resistance is felt, then pull 

briskly and smoothly.

4.  Fuel Valve Lever – 

OpEN to let fuel flow, cLOSE to 

stop the flow of fuel.

5. 

choke Lever – Used in the starting of a cold engine, 

or in cold weather conditions. The choke enriches the 

fuel mixture.

Add fuel to the tank only when the engine 

is stopped and has had an opportunity to 

cool down. In the event of a fuel spill, 

NOT attempt to start the engine until the 

fuel residue has been completely wiped up 

and the area surrounding the engine is dry.

6. 

air cleaner – Prevents dirt and other debris from 

entering the fuel system. Remove wing-nut on top of 

air filter canister to gain access to filter element.

7. 

Spark plug – Provides spark to the ignition system. 

Set spark plug gap according to engine manufacturer's 

instructions. Clean spark plug once a week.

8. 

muffler – Used to reduce noise and emissions. NeveR 

touch when

9. 

fuel Tank – Fill with unleaded gasoline. Refer to Table 

3 for fuel tank capacity. For additional information refer 

to Honda engine owner's manual.

10. 

Dipstick/Oil Filler Cap – Remove this cap to determine 

if the engine oil is low. Add oil through this filler port as 

recommended in Table 4.

11. 

Oil drain plug – Remove this plug to remove oil from 

the engine's crankcase.

12. 

engine ON/OFF Switch – ON position permits engine 

starting, 

Off position stops engine operation.

Operating the engine without an air filter, with a 

damaged air filter, or a filter in need of replacement 

will allow dirt to enter the engine, causing rapid engine 

wear.