Multiquip SP1CE13H18 ユーザーズマニュアル
SP 1 SAW CE— OPERATION AND PARTS MANUAL — REV. #3 (06/09/08) — PAGE 15
MQ STREET PRO 1 CE SAW — CONTROLS & COMPONENTS
Figures 4 shows the location of the basic controls or components
for the SP 1. Listed below is a brief explanation of each control or
component.
for the SP 1. Listed below is a brief explanation of each control or
component.
1.
Hand Grips/Handlebar – When operating the saw, place
both hands on each grip to maneuver the saw. Replace
hand grips when they become worn or damaged.
both hands on each grip to maneuver the saw. Replace
hand grips when they become worn or damaged.
2.
Handle Lock – Lock blade depth to desired position.
3.
Garden Hose Connecter – Connect to water source to
provide blade cooling while cutting concrete or asphalt.
provide blade cooling while cutting concrete or asphalt.
4.
Air Filter – Prevents dirt and debris from entering the engine
air intake. Check filter periodically and replace when
necessary.
air intake. Check filter periodically and replace when
necessary.
5.
Recoil Starter Handle – Pull to engage and start the
engine.
engine.
6.
Recoil Starter Assembly – Engages the engine when
the handle is pulled and rewinds the starter rope when the
handle is released.
the handle is pulled and rewinds the starter rope when the
handle is released.
7.
Wheels/Carriage Assembly – Heavy-duty wheels with
permanently sealed ball bearings.
permanently sealed ball bearings.
8.
Cutting Blade – Use appropriate type blades for cutting
concrete or asphalt.
concrete or asphalt.
9.
Blade Guard – Covers saw blade and flips up to allow
blade to be changed.
blade to be changed.
CONTROLS & COMPONENTS
Figure 4. SP 1 Components
10. Belt Tension Adjuster – Adjusts belt tension.
11. Front Pointer – Front pointer wheel assists in straight
tracking.
12. Front Pointer Arm – Stows up for storage and pivots down
for use.
13. Cutting Depth Adjuster – turn operating crank clockwise
or counter-clockwise to adjust the cutting depth up or down.
14. Fuel Tank – Use unleaded gasoline. Do not overfill.
15. Blade Coolant System – Provides cooling water to blade
during cutting operations.
16. V-Belt Cover – Remove this cover to gain access to the V-
belts. NEVER operate the saw with this cover removed.
17. Spindle Grease Zerks – Conveniently located for
lubrication.
18. On/Off Switch (On Engine) – Turn to the "ON" position to
allow engine to be started and turn to the "OFF" position to
shut the engine off.
shut the engine off.
19. Tool Rotation – Rotational direction of tool (blade) during
operation.
20. Engine Stop Switch (On Handlebar) – Toggle in either
direction to stop the engine.
21. Wheel Clamp – Move handle down making contact with
wheel to avoid unwanted rolling movement. Lift handle to
release.
release.
22. Water Valve – Rotate handle to turn water supply on or off.