Manualsbrain.com
  1. マニュアル
  2. ブランド
  3. Multiquip
  4. CDA45SSIU3
  5. ユーザーズマニュアル

Multiquip CDA45SSIU3 ユーザーズマニュアル

ダウンロード
ページ / 78
PAGE 28 — DCA45SSIU3 50 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #2 (12/19/08) 
OUTPUT TERMINAL PANEL CONNECTIONS
UVWO TERMINAL OUTPUT VOLTAGES
Various output voltages can be obtained using the UVWO 
output terminal lugs. The voltages at the terminals are 
dependent on the position of the Voltage Selector Switch 
and the adjustment of the Voltage Regulator Control 
Knob.
Remember the voltage selector switch determines the 
range of the output voltage. The voltage regulator (VR) 
allows the user to increase or decrease the selected 
voltage.
3Ø-220/127 UVWO Terminal Output Voltages
Place the voltage selector switch in the 3Ø 240/139 
1. 
position as shown in Figure 18..
Voltage Selector Switch
Figure 18. 
3Ø-240/139V Position
Connect the load wires to the UVWO terminals as 
2. 
shown in Figure 19.
 UVWO Terminal Lugs 
Figure 19. 
3Ø-220/127V Connections
Turn the voltage regulator knob (Figure 20) clockwise 
3. 
to increase voltage output, turn counterclockwise to 
decrease voltage output. Use voltage regulator 
adjustment knob whenever fi ne tuning of the output 
voltage is required.
Voltage Regulator Knob
Figure 20. 
3Ø-200V/1Ø-115V UVWO Terminal Output Voltages
Place the voltage selector switch in the 3Ø 240/139 
1. 
position as shown in Figure 21.
Voltage Selector Switch
Figure 21. 
3Ø-240/139V Position
Connect the load wires to the UVWO terminals as 
2. 
shown in Figure 22.
UVWO Terminal  Lugs
Figure 22. 
3Ø-200/1Ø-115V Connections Connections
NOTICE
To achieve a 3Ø 200V output the voltage selector switch 
must be in the 3Ø-240/139 position and the voltage 
regulator must be adjusted to 200V..