Multiquip C1870300404 ユーザーズマニュアル

UVWO Terminal Output Voltages
Various output voltages can be obtained using the UVWO
output terminal lugs. The voltages at the terminals are de-
pendent on the placement of the jumpers plates (6) on the
Voltage Change-Over Board and the adjustment of the
Voltage Regulator Control Knob.

Remember the voltage change-over board determines the
range of the output voltage and can be configured in two
different positions that provide 6 different output voltages at
the UVWO output terminals. The generator is shipped from
the factory in the 240V configuration. The voltage regulator
(VR) allows the user to increase or decrease the selected
voltage.

3Ø-240V UVWO Terminal Output Voltages
1. Jumper the voltage change-over board for 240V operation

as shown in Figure 21.

2. Connect the load wires to the UVWO terminals as shown

in Figure 22.

3. Turn the voltage regulator knob (Figure 23) clockwise  to

increase voltage output, turn counterclockwise to
decrease voltage output. Use voltage regulator
adjustment knob whenever fine tuning of the output
voltage is required

1Ø-240V UVWO Terminal Output Voltages
1. Make sure the voltage change-over board is jumpered

for 240V operation as shown in Figure 21 .

2. Connect the load wires to the UVWO terminals as shown

in Figure 24.

1Ø-139V UVWO Terminal Output Voltages
1. Make sure the voltage change-over board is jumpered

for 240V operation as shown in Figure 21.

2. Connect the load wires to the UVWO terminals as shown

in Figure 25.