Korg Ax3000b ユーザーズマニュアル

30

This models a bass synth. An algorithm unique to ToneWorks is used to simulate 
an analog synthesizer sound with a smoothly tracking envelope filter.

HINT: This effect is designed for single-note playing. The sound may be muddy if 
you play a chord.

HINT: The sound may be distorted depending on your settings and on how this 
effect is combined with other effects. If so, you should lower the DRIVE/AMP [VOL-
UME] or the [PROG LVL] settings.

HINT: If you want to produce the overtone structure typical of a synthesizer, it is 
sometimes best to turn off the CABINET model.

Here you can select one of 11 modulation-type effects.

*: This indicates a parameter that you can control from the expression pedal.

This models a famous chorus unit with two modes; chorus and vibrato.

[1] “DPTH/POL” -10.0–10.0

Adjusts the depth of the envelope filter (left 
half is negative motion, right half is positive 
motion).

[2] “ATTACK”

0.0–10.0

* Adjusts the attack of the envelope filter.

[3] “WAVE”

0.0–10.0

* Synth waveform.

The available choices model a variety from 
an ordinary sawtooth waveform to a sawtooth 
waveform one octave below.

[4] “RESO”

0.0–10.0

* Adjusts the resonance of the envelope filter.

[5] “MIX”

0.0–10.0

* Adjusts the mix balance between the original 

sound and the synth sound.

[1] “DEPTH”

0.0–10.0

* Adjusts the modulation depth.

[2] “SPEED”

0.1–10.0[Hz]

* Adjusts the modulation speed.

[3] “MANUAL”

1.0–10.0

* Adjusts the center frequency of the sweep. 

If DEPTH is set to 10, MANUAL will not func-
tion.

[5] “MODE”

Selects the output mode.

1:

Mono output.

2:

Stereo mode in which the effect is panned 
right, and the dry sound panned left.

3:

Vibrato mode, in which only the effected 
sound is output. Setting MANUAL to 10 will 
minimize the delay of the output.