Korg Ax3000b ユーザーズマニュアル

45

NOTE: ESS TAP1, ESS TAP2, and ESS TRIG will do nothing if the SPEED of the 
step effect is set to PEdL.

NOTE: ESS CTL2, ESS TAP1, ESS TAP2, and ESS TRIG will do nothing if ESS is 
turned off.

NOTE: For ESS TAP1 and ESS TAP2, the CONTROL switch LED will blink at the 
specified tempo.

NOTE: The maximum tap interval is 10 seconds.

If you notice that advancing the AX3000B’s expression pedal does not reach the full 
effect or volume even when the Min and Max parameters are set to the minimum 
and maximum settings, or that returning the expression pedal does not reach the 
minimum effect or volume, you will need to perform the following adjustment so that 
the AX3000B’s expression pedal will be able to reach its full range of operation.

NOTE: When adjusting the sensitivity, you should use your hand to operate the 
pedal. Accurate adjustment may not be possible if you use your foot.

1. Turn the power OFF.

2. While holding down the EXP/CTL button and the 

▲ button, turn the power on. 

The name display indicates EXP MAX.

3. Slowly return the expression pedal toward yourself (pedal back), and take your 

hand off the pedal when it stops.

NOTE: If you decide to cancel the calibration procedure, press the EXIT button.

4. Press the WRITE button. The name display indicates EXP MIN.

• “ESS CTL1”

Turn ESS on/off

• “ESS CTL2”

Turn the effect being controlled by ESS on/off

• “ESS TAP1”

Use tap tempo to specify the duration until the next step

• “ESS TAP2”

Use tap tempo to specify the length from step 1 until the 
last step  (if in Alternate mode, the length of one cycle 
back to step 1)

• “ESS TRIG”

The sequence will begin from step 1

Press slowly

Name display