Multiquip EC-42S ユーザーズマニュアル

2. As the drum rotates, use a shovel  (Figure 19) to place the

cement mix inside the drum, add water as required. Be careful
to only place the 

tip of the shovel inside the drum.

3. Placing the shovel all the way inside the drum (Figure 20) will

cause the shovel to strike the blades.  This condition will make
the shovel rotate, and could cause injury to personnel.
NEVER place hands inside the mixing drum while it is
rotating.

1. To position the tub, make sure the mixer is placed on firm

 level

ground,

 then pull up on the dump latch (Figure 18) and turn

the 

hand wheel until the tub is at the desired position. Once

the tub is at the desired position, 

pull down on the dump latch

to lock the tub in position.

1.

Push the main 

start/stop switch (Figure 21) inward to stop

the engine.

1.

Place the electric motor's 

ON/OFF switch  (Figure 22) in

the OFF position.

2.

Disconnect the electric motor's extension cord from its
power source.

3.

Clean drum of all debris and foreign matter.

2.

Place fuel shut-off lever in the OFF position.

3.

Clean drum of all debris and foreign matter.

NEVER stand in front or behind the mixing
drum while it is being placed in the dump

position. Stay clear of the mixing drum while
it is being positioned.