Multiquip MC3H ユーザーズマニュアル

This mixer is 

only intended for the production of concrete,

mortar and plaster.  The mixer must be used for its intended
purposes and is not suitable for the mixing of 

flammable or

explosive substances.  The mixer must not be used in an
explosive atmosphere.

This portable mixer is powered by either a Honda G100K2,
4-stroke, side valve, single cylinder, gasoline engine rated
at 2.5 hp @3,600 rpm. or a 0.75 hp electric moto

r.

The drum is instantly removable by unscrewing counter-
clockwise. When inserting drum onto gearbox shaft, make sure
that drum is fully screwed onto shoulder or threads may be
damaged. Use extreme care when screwing on the drum,
spinning drum onto the gearbox shaft too fast may damage
gearbox.

If mixer is equipped with an 

electric motor, make sure that

the power being supplied to the motor corresponds to the
voltage rating label on the motor. Supplying the wrong voltage
to the electric motor will cause severe electrical damage to
the motor.

Always make sure that 

OFF/ON switch on the electric motor

is in the 

OFF position before applying power.

It is 

strongly recommended that when plugging in the

mixer's power cord into a receptacle, that a G.F.C.I. (

Fault Current Interrupter) receptacle be used.

The extension cable should be a 3-wire configuration that
includes a ground wire that conforms to UL code. The wire
cross section must be a minimum of 2.5 mm

2

 . Choose an

extension cord of adequate current carrying as Reference in
Table 5. Remember

 distance affects the wire size of the

extension cable.

Ensure that the extension cable is carefully laid out avoid-
ing 

wet areas, sharp edges and locations where vehicles

might run over it. Avoid allowing the extension cable to be
trapped underneath the mixer.

Unroll the extension cable fully or it will overheat and could
catch fire.  Make sure that all extension cable connections
are dry and safe. Replace any defective or badly worn ex-
tension cable immediately.

When using a 

portable generator it must have a minimum

output of 2.5 kw and be continuous rated.

The gearbox oil level has been preset at the 

factory prior to

shipping. Before inspecting the gearbox oil level (Figures 30
and 31), make sure the gearbox is cold before removing the
filler plug.  Fill up with EP90. or similar gear oil.

Use a ramp (Figure 3) to load and unload the mixer from the
transport vehicle. Never drop the mixer onto the ground; damage
to the mixer could result.