Multiquip MC3H ユーザーズマニュアル
MIX N' GO MIXER — PARTS & OPERATION MANUAL — REV. #1 (09/09/02) — PAGE 23
MIX N' GO MIXER — INITIAL START-UP (GASOLINE ENGINE)
Starting the Engine (
HONDA engine)
1. Place the engine
fuel valve lever (Figure 20) to the "ON"
position.
DO NOT attempt to operate the mixer until
the Safety, General Information and
Inspection sections of this manual have
been read and thoroughly understood.
the Safety, General Information and
Inspection sections of this manual have
been read and thoroughly understood.
2. Place the trowel's
throttle lever (Figure 21) to the "IDLE"
position.
Figure 20. Engine Fuel Valve Lever (ON Position)
Figure 21. Throttle Lever (Idle Position)
3. Place the
choke lever (Figure 22) in the "OPEN " position
if starting a
cold engine.
4. Place the
choke lever (Figure 23) in the "CLOSED " position
if starting a
warm engine or the temperature is warm.
Figure 22. Engine Choke Lever (Open)
Figure 23. Engine Choke Lever (Closed)
5. Place the
engine ON/OFF switch (Figure 24) in the "ON "
position.
Figure 24. Engine ON/OFF Switch (ON Position)
This section is intended to assist the operator with the initial
start-up of the walk-behind trowel. It is extremely important that
this section be read carefully before attempting to use the trowel
in the field.
start-up of the walk-behind trowel. It is extremely important that
this section be read carefully before attempting to use the trowel
in the field.