Agilent Technologies 42A ユーザーズマニュアル
2- 24
Front-Panel Overview
To modify the display grid
To modify the display grid
1 Press the
Display
key.
2 Turn the Entry knob to change the intensity of the displayed grid. The
intensity level is shown in the
Grid
softkey and is adjustable from 0 to
100%.
Each major division in the grid (also know as graticule) corresponds to the
sweep speed time shown in the status line on the top of the display.
sweep speed time shown in the status line on the top of the display.
• To change waveform intensity, turn the
INTENSITY
knob on the
lower-left corner of the front panel.
To print the display
You can print the complete display, including the status line and softkeys, to a
parallel printer or to the floppy disk by pressing the
parallel printer or to the floppy disk by pressing the
Quick Print key. You can
stop printing by pressing the
Cancel Print softkey.
To set up your printer, press the
Utility key, then press the Print Confg softkey.
For more information on printing and floppy disk operation, refer to the
“Utilities” chapter.
“Utilities” chapter.