Multiquip PS706020 ユーザーズマニュアル
PAGE 22 — PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08)
PS7060 MULTIQUIP SAW — BASIC ENGINE INFORMATION
Figure 7. Basic Engine Components
Basic Engine Components
The following refer to basic engine components and their functions
that an operator may need to reference . The manufacturer's engine
manual provides further instructions and details of operation and
servicing. The engine shown in Figure 7 is a Deutz BF3L2011
engine.
that an operator may need to reference . The manufacturer's engine
manual provides further instructions and details of operation and
servicing. The engine shown in Figure 7 is a Deutz BF3L2011
engine.
2.
Governor Lever – This lever restricts engine speed (high
idle and low idle) through a speed control device linked to
the accelerator system.
idle and low idle) through a speed control device linked to
the accelerator system.
3.
Oil Dip Stick – Remove to check amount and condition of
oil in crankcase.
oil in crankcase.
4.
Oil Filter – Spin-on type, filters oil for contaminants.
5.
Oil Drain Plug & Hose – Remove plug and attach drain
hose to drain crankcase oil.
hose to drain crankcase oil.
6.
Oil Filler Port – Remove to add fresh crankcase oil.
7.
Crankshaft V-Pulley – Check fan V-belt between V-Pulley
and fan to determine proper belt tension.
and fan to determine proper belt tension.
8.
Cooling Fan – Driven by the V-belt, the cooling fan cools
the engine by cooling engine oil that circulates through the
engine block and cylinder head.
the engine by cooling engine oil that circulates through the
engine block and cylinder head.
9.
V-belt Tension Adjustment – This bolt provides means
to adjust the V-belt tension at the alternator bracket.
to adjust the V-belt tension at the alternator bracket.
16. Air Intake Port – Provides air from the air cleaner to the
turbocharger unit.
10. V-belt (Fan belt) – Driven by the engine crank during
operation, drives the fan as well as the aternator.
13. Alternator – Located inside the fan assembly. Provides
current to the electrical system and charges the battery.
Driven by means of a crankshaft/V-belt pulley system.
Driven by means of a crankshaft/V-belt pulley system.
14. Starter – Starts engine when ignition key is rotated to the
"START" position.
12. Lifting Eye – The lifting eye is provided if the removal/
installation of the engine becomes necessary.
11. Oil Fill Cap – Remove to add engine oil.
1.
Fuel Filter – Removes dirt and water from the engine fuel.
15. Flywheel – Main power is taken off from the flywheel end.
17. Turbocharger – Provides pressurized intake air to the
cylinder by means of a turbine energized by exhaust gas
that rotates the blower.
that rotates the blower.
18. Air Cleaner Assembly – Provides clean filtered air to the
air intake port.
17
7
9
10
13
16
5
6
12
14
8
4
1
3
11
2
18
15