Multiquip MVC88VTH ユーザーズマニュアル

1.  Once the engine has started, move the engine throttle 

lever quickly to the

 run position. 

2.  With the throttle lever in the run position, the engine 

speed should be around 2,300 RPM, therefore 

engaging the centrifugal clutch.

3.  Firmly gasp the compactor's handle bar with both 

hands, the compactor will begin moving forward.

4.  Slowly walk behind the compactor and be on the 

lookout for any large objects or foreign matter that 

might cause damage to the compactor or bodily injury.

5.  Compactor traveling speed may drop on soils which 

contain clay, however there may be cases where 

traveling speed drops because the compaction plate 

does not leave the ground surface easily due to the 

composition of the soil. To rectify this problem do the 

following:

 

„

Check the bottom plate to see if clay or equivalent 

material has been lodge in the plate mechanism. If so, 

wash with water and remove.

 

„

Remember the compactor does not work as efficiently 

on clay or soils that have a high moisture content level.

 

„

If the soil has a high moisture level, dry soil to appropriate 

moisture content level or carry out compaction twice.

aLWays follow all safety rules referenced 

in the safety section of this manual before 

operating compactor. Keep work area 

clear of debris and other objects that 

could cause damage to the compactor or 

bodily injury.

aLWays move the throttle lever quickly without 

hesitation, because increasing the engine speed slowly 

causes the clutch to slip.

neVeR  stop the engine suddenly while working at 

high speeds.

1.  Move the throttle lever to the 

idle position (Figure 20) 

and run the engine for three minutes at low speed.

2.  Place the engine ON/OFF switch (Figure 21) in the 

"

OFF" position.

3.  Place the fuel shut-off lever (Figure 22) in the "

OFF" 

position.

4.  If applicable place water valve (Figure 18) in the 

OFF 

position.

1.  Move the throttle lever quickly to the 

idLe position, and 

place the engine ON/OFF switch in the 

OFF position.

ENGINE SWITCH

ON

OFF