Mitsubishi Electronics MDS-D-SPJ3 ユーザーズマニュアル

4 - 16

There is a limit to the load that can be applied on the motor shaft. Make sure that the load applied on the 

radial direction and thrust direction, when mounted on the machine, is below the tolerable values given 

below. These loads may affect the motor output torque, so consider them when designing the machine.

(Note 1) The tolerable radial load and thrust load in the above table are values applied when each motor is 

used independently.

(Note 2) The symbol L in the table refers to the value of L below.

L: Length from flange installation surface to center of load mass [mm]

0°C to +40°C (with no freezing)

80% RH or less (with no dew condensation)

-15°C to +70°C (with no freezing)

90% RH or less (with no dew condensation)

Indoors (no direct sunlight)

No corrosive gas, inflammable gas, oil mist or dust

Operation / storage: 1000m or less above sea level

Transportation: 10000m or less above sea level 

245N (L=30)

98N

392N (L=40)

147N

245N (L=33)

147N

980N (L=55)

490N

2058N (L=79)

980N

 

Radial load

Thrust load

L