Mentor v8.6_4 ユーザーズマニュアル

FastScan and FlexTest Reference Manual, V8.6_4

Tools Supported: FastScan

Scope: Atpg, Good, and Fault modes

WRIte PAths filename [-All | {-Path gate_id_begin gate_id_end}] [-Replace]

Writes the path definitions of the loaded paths into the file that you specify.

The Write Paths command is identical to the Report Paths command, except that
the data is written into a file. The Write Paths command writes into a file the
internal path list definitions for the paths that you specify. You load the path
definitions into the internal path list by using the Load Paths command.

•

A required string that specifies the name of the file to which FastScan writes
the path delay fault information.

•

-All

An optional switch that writes the information on all the path delay faults in the
current fault list. This is the default.

•

-Path gate_id_begin gate_id_end

An optional switch and two integer triplet that specifies a particular path or
portion of a path whose definition you want to write. You use this argument to
write paths that were not defined in a path definition file and therefore were not
loaded using the Load Paths command.

The two integer arguments specify two gate identification numbers that
indicate the beginning and end of the path. The path begins at gate_id_begin
and ends with gate_id_end.

The value of the gate_id_begin and gate_id_end arguments is the unique gate
identification number that FastScan automatically assigns to every gate within
the design during the model flattening process.