Lorex Technology L20WD800 Series ユーザーズマニュアル

Rear Panel

1. 6 PIN DIN VIDEO INPUTS - Channel 1-4 Camera inputs (for cameras with 6 

Pin DIN connections). 

Cameras with 6 Pin DIN connections draw power from the System - additional 
power adapters are not needed.

2. BNC VIDEO INPUTS - Channel 1-8 camera inputs (used to connect Cameras with BNC 

connection type). Cameras with BNC connections require an additional power adaptor. 

3. VGA INPUT - Connect a PC (or other devices with a VGA Output) to the System. The System 

will perform as a Computer Monitor (when in VGA Mode).

4. COMPONENT VIDEO IN - Connect a DVD Player, Set Top Box or Satellite Receiver to the 

component Video Inputs (Y/Pb/Pr).

5. COMPONENT AUDIO IN - Connect a DVD Player, Set Top Box or Satellite Receiver to the 

component Audio Inputs (Audio in Left/Right Channels). The Component (Composite) Output 
must be turned ON on most DVD Players before connection to the System.

6. RELAY / PTZ / RS-232 BLOCK - These terminals are used to send a signal to a secondary 

device or control PTZ (Pan/Tilt/Zoom) type cameras.

7. ETHERNET PORT - Connects the monitor to a router for connection to the internet. Refer to 

Appendix #3 for Remote Connection setup.

8. DC INPUT - Connect the AC power using the power cord provided with the unit from the monitor 

to an electrical outlet 

9. RCA AUDIO INPUTS - Channel 1-4 Audio inputs (for BNC type cameras with standard RCA 

Audio output)

1. DIN Video Inputs

3. VGA IN Port

2. BNC Video Inputs

4. Component Video IN

6. Relay / PTZ / RS-232

7. Ethernet

8. Power (DC 12V)

10. Spot Out

9. Audio Inputs

11. Audio Out

12. Alarm Block

5. Component Audio IN