Lorex Technology L20WD800 Series ユーザーズマニュアル

Simple Recording Mode

Select a single or multiple time blocks:

• Mouse Control: Click a single block to 

open the Recording Type Menu. Click 
and Drag a block of times to configure 
multiple channels and times at once.

•  Remote Control & Front Panel: 

Navigate to the Channel Block section, 
and the entire block will be highlighted 
with a White outline: 

z

Press the ENTER button to access the 
Time Blocks - the first hour on Channel 1 
will be highlighted in Yellow. 

z

Navigate to the desired time block, and 
press the ENTER button to activate the 
block - if a single block is desired, press 
ENTER a second time. 

z

To select multiple blocks, use the arrows 
to drag the cursor until the desired time 
blocks are selected and press the 
ENTER key.

The Recording Selection menu will open. 
Select ONE of:

• None
• Continuous Recording
• Motion Recording
• Alarm Recording

Once a selection has been made, the 
Recording Selection window will close.

The Recording Operation Menu allows the 
user to switch between Simple and 
Advanced Modes, set the Recording 
Schedule, and change the Pre and Post 
Event Recording times.

•  RECORDING MODE - Changes the 

Recording mode from Simple to 
Advanced.

• SCHEDULE MODE- Sets the Scheduled 

Recording Mode to Daily or Weekly:

z

If you set the Schedule Mode to Daily, all 
settings made to the Continuous/Motion 
& Alarm Setup menus will affect all days 
in the same way. 

z

If you set the Schedule Mode to Weekly, 
the settings can be set differently for 
each day of the week.

• PRE EVENT RECORDING - When an 

alarm is detected, the Pre Alarm will 
begin recording before the Alarm was 
detected (retrieved from video cache). 
The Pre Alarm Recording Time can be 
set to between 1~5 seconds. 

• POST EVENT RECORDING - When an 

alarm is detected, the Post Alarm will 
remain recording for the specified time. 
The Post Alarm Recording Time can be 
set to between 5~180 seconds.