Marshall electronic V-LCD70P-HDA ユーザーズマニュアル
12
On-Screen Menu (continued)
VIDEO CONFIGURATION SUBMENU (continued)
Pixel-to-Pixel Mode
Use this setting to enable Pixel-to-Pixel mode.
This mode bypasses the monitor’s internal scaling function and displays incoming images in their native resolution and
aspect ratio, with a one-to-one mapping:
This mode bypasses the monitor’s internal scaling function and displays incoming images in their native resolution and
aspect ratio, with a one-to-one mapping:
•
For incoming formats smaller than the native resolution of the LCD panel (800 x 480), the image will be displayed
in the center of the screen using only the necessary LCD pixels. For example, NTSC images will occupy exactly
720 x 480 pixels. The surrounding pixels will be black.
in the center of the screen using only the necessary LCD pixels. For example, NTSC images will occupy exactly
720 x 480 pixels. The surrounding pixels will be black.
•
For incoming formats exceeding 800 x 480 pixels, only the center 800 x 480 of the incoming image will displayed
occupying the whole screen, with the remainder of the picture cropped. For example, 1080i formats will both be
cropped to 800 x 480 and displayed full-screen.
occupying the whole screen, with the remainder of the picture cropped. For example, 1080i formats will both be
cropped to 800 x 480 and displayed full-screen.
Note: Pixel-to-Pixel mode disables aspect ratio control and H/V Delay.
H/V Delay
Use this setting to enable one of three delay modes (H & V Delay, V Delay, H Delay):
•
In H & V Delay mode, both horizontal sync and vertical sync are delayed, resulting in both horizontal and vertical
blanking periods being shown on the screen.
blanking periods being shown on the screen.
•
In V Delay mode, vertical sync is delayed so that the vertical blanking period is displayed on screen.
•
In H Delay mode, horizontal sync is delayed so that the horizontal blanking period is displayed on the screen.
Underscan
Use this setting to enable or disable Underscan mode:
•
When Underscan is OFF, the active portion of the video signal is displayed on the screen, with 0% overscan.
•
When Underscan is ON, the area around the active video area is displayed on the screen, resulting in blanking
intervals being shown around the perimeter of the active image. Use this mode to clearly view the edges of the
active video area.
intervals being shown around the perimeter of the active image. Use this mode to clearly view the edges of the
active video area.
NTSC Black Level
Set the NTSC Black Level according to the type of NTSC composite video input:
•
7.5 IRE: Use this setting for standard NTSC-M signals which use a 7.5 IRE setup (black level).
•
0 IRE: Use this setting for NTSC-J signals which have no setup, or a black level of 0 IRE.
Note: This setting is disabled for PAL composite input and all component formats.