Echo 2 ユーザーズマニュアル

 30  
 

 

output bus tabs.  AudioFire12 does not have S/PDIF, so it does not have a digital 
output bus; it has 6 analog output bus tabs instead.   
 

NOTE: Analog outputs 3 and 4 for the AudioFire2 are labeled as 
“Headphones” in the console. 

 

 
The master bus control is the area on the far right of the console window. It is 
outlined in purple in the picture above.  At the top are the labels “ANALOG”, “Out 
1”, and “Out 2.”  This indicates you are currently controlling everything mixed to 
analog outputs 1 and 2.  These channels correspond to the currently selected output 
bus tab. 
 
Beneath the labels are two green label fields that can be changed by clicking in 
them and typing. Below the green label fields are nominal level buttons, mute 
buttons, level meters and faders. The mute buttons and faders affect everything 
being mixed to this bus.  Thus, pulling the fader down will make both the input 
monitors and playback quieter.  The level meters display the amount of signal 
being sent out of the selected outputs.  
 
The gang button sets the gang mode.  If you are in gang mode, the mute buttons 
will work together for the left and right channels; for example, clicking the mute 
on one channel activates the mute button on the other channel.  Also, ganging ties 
the faders together so they will maintain their relative placement in regard to each 
other. 
 

 
The controls for the analog inputs are on the left side of the console and have the 
labels “ANALOG” and “1” through “8” at the top.  They are outlined in red in the 
picture above. There is one strip, or input channel, corresponding to each of 
AudioFire8’s eight physical analog inputs. The input level meters remain visible at 
all times, whereas the input monitor controls (pan, solo, mute, faders and gang) 
that you see will change depending on which output bus is currently selected.