Marantz Portable Solid State Recorder ユーザーズマニュアル

The display returns to RAW Mode flashing.

You can:

•

Press and release the F.FWD/+ button 

 or the -/

F.REV button

 to tab to another menu choice, or

•

Press and release the  

MENU/STORE button to

write the menu changes and return to stop mode, or

•

Press and release the CANCEL button 

 to cancel all

menu changes and return to stop mode.

Verify is an automatic, electronic, Read After
Write check. With Verify On, the PMD671 con-
tinually reads the CF card about one second
after the recording. It compares what is recorded
to the source signal. A mismatch results in an
error message.

Verify does not depend on the position of the
MONITOR switch.

See charts on page 14.

Press & hold 

MENU/STORE 2 sec ....... Preset

Double Click ENTER 

.................. RecFormat

Press F.FWD/+ 

 until ............................ Verify

Press ENTER 

..................................... Off/On

Press F.FWD/+ 

........................ toggle Off/On

Press ENTER 

...................................... Verify

Press 

MENU/STORE .................... store & exit

1. From stop, press and hold the 

MENU/

STORE button for about 2 seconds. Preset
will appear (flashing) in the display.

2. While Preset is

flashing, double
click the EN-

TER button 

.

Example display
A menu choice will be flashing.

4. With Verify flash-

ing, press and
release the

3. Press and release

the F.FWD/+
button 

 until

ENTER button 

.

Verify menu choice is flashing.

5. Press and re-

lease the F.FWD/
+ button 

 to

toggle between On and Off.

6. When the desired state is displayed, press

and release the
ENTER button

.

The display returns to Verify flashing.

You can:
•

Press and release the F.FWD/+ button 

 or the -/

F.REV button

 to tab to another menu choice, or

•

Press and release the  

MENU/STORE button to

write the menu changes and return to stop mode, or

•

Press and release the CANCEL button 

 to cancel all

menu changes and return to stop mode.

Power Up Pre Record buffers (remembers) audio
during REC PAUSE. When you slide the REC
switch to engage record, CONT? is displayed.

• Press and release the PLAY button 

 to

record the buffered audio and continue
recording.

• Slide and release the REC switch again to

discard the buffered audio and continue
recording from that point.

• Press and release the STOP button 

 to

discard the buffered audio and stop record-
ing.

Note:
If there is less than 5 minutes of REC REMAIN time
PupPreRec does not work.

Verify is displayed.