Mitsumi electronic 12 ユーザーズマニュアル

10

GB

The following section gives a small example of 
how to start creating applications quickly. The 
example follows the whole sequence from buil-
ding up an application to executing to the PLC 
system. The terminal must be connected to a 
personal computer with the PC software. In this 
example we shall make a textblock which shows 
the status of the X0 input. 

Start the PC software. First we have to create a 
project. Select New in the File menu. In the dia-
logue box displayed you select terminal type 
and PLC system. Then press OK. (See Set-
tings).

The Block list will now be displayed. Select 
New to create a textblock. Now the Block hea-
der is displayed.

In this example we shall define a textblock. 

1. Enter the number of the block here, in this 

case 0. 

2. Click on the button Status...

3. Mark the alternative Put cursor at first 

man. object.

4. Press OK. 
5. Press OK to begin editing the block. A field 

will be shown. 

6. Select Digital text in the Object menu.
7. First enter which I/O signal the object is to 

illustrate. Do this by entering the required 
address, in this case X0, after the text Digi-
tal signal. Press the Tab key to move the 
cursor to the next field.

8. Enter the text which will be displayed when 

the signal is 0, in this example OFF. Press 
the Tab key.

9. Enter the text which will be displayed when 

Mac10eng  Seite 10  Freitag, 5. Februar 1999  3:29 15