Motorola 1.0.1 ユーザーズマニュアル
Chapter 2: Device Installation
•
15 foot power cable assembly
The Network Operator must supply the following:
•
Mounting Location
•
Power Source (12V DC) (from vehicle or other DC power supply)
•
A Hub or Switch (if more then 1 Ethernet device will be used)
•
Hand tools for bracket installation
MAC Address Label Location
The transceiver and SBC (Ethernet) MAC addresses for the VMM6300 and for the VMM7300 are
listed on the label located either on the front side or on the back of the VMM unit. Record these
numbers in the MAC Address Tables provided in the next section.
listed on the label located either on the front side or on the back of the VMM unit. Record these
numbers in the MAC Address Tables provided in the next section.
The figure below is only a sample VMM label, an actual device label for either of the VMM devices
will be designated accordingly.
will be designated accordingly.
Figure 2-1
VMM Sample Device Label
6881011Y54-A
2-2
September 2005