Fujitsu 480 ユーザーズマニュアル

8-96

C122-E003-02EN

GSWB
CHAPTER 8 CLI Operations

 

This command specifies the monitored ports.  However, no setting can be made for a 
port-channel.

A change only to the defined traffic direction is not possible.  A reset is required after 
an entry is deleted.  Any interface specified by the monitor session destination 
command cannot be registered.

The show monitor session source command can be used to check registered entries.  If 
no entry is registered, nothing is displayed.

By default, no entry is registered.

• Specifies a monitored port

• Removes a monitored port from port monitoring

z <interface-id>

Specifies the source interface (GigabitEthernet 0/1 to 0/8, IO_Units 00 to 71, 
10GigabitEthernet 1/1 to 1/2, ports 1 to 26).

z rx | tx | both (optional)

Specifies the traffic direction.  The default setting is [both].

- rx: Incoming
- tx: Outgoing
- both: Bidirectional

Global

monitor session source interface <interface-id> [rx | tx | both]

no monitor session source interface <interface-id>