Mitsumi electronic NZ2GF-ETB ユーザーズマニュアル
175
CHAPTER 10 CONFIGURATION TOOL
10
10.1 Star
tin
g Procedure
10.1.1
P
repara
tion b
efore start
ing the
tool
CHAPTER 10
CONFIGURATION TOOL
This chapter describes the starting procedure, window structures, and functions of the configuration tool.
10.1
Starting Procedure
10.1.1
Preparation before starting the tool
(1) Connecting the Ethernet adapter module and a configuration computer
They can be connected via a switching hub or directly. (
(2) Checking the operating environment of the personal computer
Check the operating environment of the personal computer. (
Install the .NET Framework 2.0 SP2 or later if it is not installed.
(3) Configuring the personal computer
Set the same value for each network part of the IP addresses of the Ethernet adapter module and the personal
computer. For the host part of the IP address, the Ethernet adapter module must have a different value from that
of the personal computer.
The following IP address and subnet mask values are set for the Ethernet adapter module by default.
computer. For the host part of the IP address, the Ethernet adapter module must have a different value from that
of the personal computer.
The following IP address and subnet mask values are set for the Ethernet adapter module by default.
• IP address: 192.168.3.30
• Subnet mask: 255.255.255.0
• Subnet mask: 255.255.255.0
When starting up the configuration tool the first time, configure network settings of the personal computer
according to the IP address and subnet mask values shown above.
according to the IP address and subnet mask values shown above.
Ethernet adapter module
10. 97. 79.
8
255.255.240.
0
Network part
Host part
10. 97. 79.
30
255.255.240.
0
Network part
Host part
Set different values.
Set identical values.
IP address
Subnet mask