Mitsumi electronic NZ2GF-ETB ユーザーズマニュアル

189

CHAPTER 10 CONFIGURATION TOOL

10.3  Par

ameters

10.3.3 

 E

th

ernet setting

Configure the settings for connecting the Ethernet Adapter Module to the Ethernet.

Setting item tree 

 NZ2GF-ETB 

 [Parameter] 

 "Ethernet"

The following table lists the setting items on the dialog box.

*1 

Restrictions apply to IP addresses that can be set to perform the communications described on the next page. Build the 
system so that the IP address within each setting range described on the next page can be set.

IP Address

Input Format

Select an input format for the IP address and subnet mask pattern.

DEC/HEX
(Default: DEC)

IP Address

Set the IP address of the Ethernet Adapter Module.
If the IP address was changed, configure the network settings again. 

(

 

• Decimal input

0.0.0.1 to 223.255.255.254

*1

(Default: 192.168.3.30)

• Hexadecimal input

0.0.0.1 to DF.FF.FF.FE

*1

(Default: C0.A8.03.1E)

Subnet Mask 
Pattern

Set the subnet mask of the Ethernet Adapter Module.
If the subnet mask was changed, configure the network settings again. 

(

 

Page 175, Section 10.1.1 (3))

• Decimal input

192.0.0.0 to 255.255.255.252
(Default: 255.255.255.0)

• Hexadecimal input

C0.0.0.0 to FF.FF.FF.FC
(Default: FF.FF.FF.00)

Communication Mode

Set the communication mode.

Auto Negotiation
100Mbps/Half Duplex
100Mbps/Full Duplex
(Default: Auto Negotiation)

Connection Setting

Set connections. (

 



Disable direct MELSOFT connection.

Specify whether to disable direct connections to MELSOFT.

Disable/not disable
(Default: Not disable)